Publicidad
Idiomas disponibles
Idiomas disponibles
5. ROOM TEMPERATURE
When the thermometer is in stand-by mode ("Peak Performance" - see par. #4.1 and
#7), the room temperature remains displayed automatically for 4 hours after the last
reading is taken and the symbol
flashes.
To display the room temperature on the backlit display, while the thermometer is in
stand-by mode, press the "Mem"
button once: the display illuminates in orange
showing the room temperature and the symbol
flashing.
6. MEMORY FUNCTION
The "Mem"
button lets you call up the last 9 temperature readings.
To activate this function, press the "Mem"
button twice: the display will light up
in violet and will show the value of the last reading accompanied by the number 1 and
the symbol
or
depending on which button was used for that reading.
Pressing the button again calls up the second to last, third to last reading and so on,
accompanied by the numbers 2, 3, etc.
7. HOW TO CHANGE THE SETTINGS
Depending on where it is to be sold, your thermometer leaves the factory as follows:
• preset to Celsius (°C) or Fahrenheit (°F);
• referred to oral ("ORAL") or rectal ("RECTAL") or axillary ("AXILLA") or internal
temperature readings ("CorE") or only internal temperature readings (no symbol
shown);
• with display off when in stand-by mode ("Energy Saving", off
) or always on ("Peak
Performance" - on
).
If necessary, these settings can be modified as follows:
1. while the thermometer is off or in stand-by mode, press the "Mem"
button and
hold it down; after about 8 seconds the visualization on the display changes showing
in rotation the following combinations (the active settings are highlighted in green):
2. When the new desired setting appears, release the button. The purple backlight will
turn green. Only one setting can be modified at a time.
Note:
- if the thermometer was produced with the sole internal temperature setting, the
ORAL, RECTAL, AXILLA and CORE settings would not be available for changing.
- The measurement of the body temperature must be taken always at the centre of the
forehead (par. #4.1) or at the eyelid (par. #4.2), no matter what the current setting is: in fact,
the axillary, oral, rectal or core settings provide a forehead temperature value that is a valid
approximation of the axillary, oral or rectal/internal temperature respectively (see par. #3).
- 18 -
Publicidad
