Kohler K-5548-K1-TT Guía De Instalación Y Cuidado página 12

16" (406 mm) White
Crossover Cable
Control Cable
Input (Location
Varies By Model)
Steam
Adapter
Terminator
25' (7.6 m)
Data Cable
5. Install the Adapter – Single Steam Head
Remove the adhesive backing from the steam adapter.
Mount the adapter firmly to the side of the steam generator.
NOTICE: Do not pinch, nail, wedge, or use undue force when
handling the silver crossover cable. Any damage may result in
adapter failure. If the adapter is not installed immediately, protect
the cable ends with tape or other shielding material.
NOTE: The terminator should be installed if no additional
equipment is to be added in series to this device. If additional
equipment is to be connected downstream of this device, remove the
terminator and follow the instructions packed with the additional
equipment.
Apply dielectric grease in all the connectors and wires.
Connect the 16" (406 mm) white crossover cable to the steam
adapter and the steam generator.
Connect the temperature sensor wire to the corresponding port
on the steam adapter.
1235393-2-E
Temperature
Sensor
Steam
Head
Controller
12
Interface
Kohler Co.