Using The Controls - Hamilton Beach Summit HBH850 Manual De Uso

Licuadora para bar
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Using the Controls

There are several blending options available, including AUTOBLEND, JUMP cycles, HIGH, or LOW cycles,
each with adjustable time settings. You may also store favorite settings for later use with the A, B, C, or D
buttons. For quick blending or to "freshen up" a beverage, use the PULSE button.
AUTOBLEND
START, SCROLL TO SET
JUMP 4–12 sec
START, SCROLL TO SET
JUMP
LOW/HIGH 12 sec
HIGH
LOW
PULSE
PULSE
A
A B C D
D
0
START
START
START
0 sec
START
STOP
MORE
This is the default screen for the blender or if AUTOBLEND
is pressed . On setting 0, the blender senses when the drink
is finished and stops automatically. Press the ▲ or ▼ button
to change to AUTOBLEND 1, 2, or 3 to add additional
time. Press START to run the cycle.
Pressing JUMP displays the default jump cycle times (4
seconds at low then 12 seconds at high). Press the ▲ or
▼ button to change the cycle length. Press START to run
the cycle.
Pressing HIGH or LOW displays the current run time for
that speed. Press the ▲ or ▼ button to change the cycle
length. Press START to run the cycle.
Press and hold the PULSE button to run the blender at
HIGH speed. Release to stop blender. Display will indicate
the length of time the button is held.
These buttons allow you to save your favorite settings.
Select A, B, C, or D and press START to run the cycle
stored in that location. To store a new cycle, adjust the
speed and time settings, then press and hold the A, B,
C, or D button to save it to that location. A confirmation
message will show when the cycle is SAVED.
NOTE: Saving a new cycle to a location will overwrite any
existing cycle in that location.
Pressing STOP will stop any cycle currently in use.
Pressing the MORE button displays cycle count screens
and other diagnostic information. See the next page for
more information.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido