Publicidad
Idiomas disponibles
Idiomas disponibles
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these
instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that
may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly
maintained power tools.
f. Use the power tool, accessories and tool bits etc., in accordance with these instructions, taking into account the working
conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a
hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the
safety of the power tool is maintained.
6. Electrical Safety
Your tool is double insulated; therefore no earth wire is required.
Always check that the main voltage corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must be replaced by the manufacturer, authorized Black & Decker Service Center
or an equally qualified person in order to avoid damage or injury. If the power cord is replaced by an equally qualified person,
but not authorized by Black & Decker, the warranty will not be valid.
7. Labels on Tool
The label on your tool may include the following symbols:
Read Instruction Manual
Use Eye Protection
Use Ear Protection
V.......................... Volts
A......................... Amperes
Hz........................Hertz
W......................... Watts
min......................minutes
.......................Alternating current
• Use the guard and ensure it is fitted correctly.
• Check mounting flanges and the disc are correctly fitted and are undamaged.
• Ensure you are using the correct size and type of disc for the task.
• Ensure the disc, wire brush and sanding accessories are rated in excess of the spindle rpm of your angle grinder. Allow a newly assembled
wheel to idle off-load for 30 seconds before starting any operation.
FEATURES (FIG. 1)
1. Slider switch
2. Cable
3. Tool free guard
4. Body grip
5. Side handle (3 positions)
6. Spindle lock button
ADDITIONAL SAFETY INSTRUCTIONS
FOR SMALL ANGLE GRINDERS
................... Direct current
n
........................ No load speed
0
....................... Class II construction
....................... Earthing terminal
....................... Safety alert symbol
.../min..................Revolutions or reciprocations per minute
13
ENGLISH
Publicidad
