Publicidad
Idiomas disponibles
Idiomas disponibles
Mounted in control panel front – standard
(operated from the front – vertical)
Recommended size of hole: 186 x 201 mm.
1
Maximum thickness of plate/door: 20 mm.
Fasten the OD 401 with the four TORX
screws, type M5 x 25 PH-FZB, supplied
(pos. 1).
Max. 20 mm
Mounted in control panel front
(operated from above or from below –
tilt angle 12°)
The mounting kit must be ordered separately.
Recommended size of hole: 186 x 201 mm.
Maximum thickness of plate/door: 20 mm.
Fasten the OD 401 with the four TORX
screws, type M5 x 40 PH-FZB, supplied
(pos. 1).
1
Max. 20 mm
Mounted in specially designed cabinet
(operated from above – tilt angle 12°)
The mounting kit must be ordered separately.
3
Fit the stainless-steel frame to the wall or
another solid surface. The three holes on the
back of the frame lie on a circle with a diame-
1
ter of 170 mm. Fasten the frame with three
screws (pos. 3).
Fit the cable gland in the bottom of the cabi-
net. Insert the cable through the gland.
Note: The cable between the OD 401 and the
CU 401 must be min. H05VV-F according to
the CENELEC HAR standard.
Fasten the OD 401 with the four TORX
screws, type M5 x 40 PH-FZB, supplied
(pos. 1).
Assemble the operator display and the stain-
less-steel frame with the four hexagon socket
head screws, type M4 x 6 US-A4, supplied
2
(pos. 2).
8
Publicidad
