Agri-Fab 45-0613 Manual Del Usuario página 10

ASSEMBLE THE LIFT HANDLE
STEP 10:
(SEE FIGURE 10)
• Attach the release grip assembly (14) to the lift handle
tube assembly (15) using a hex bolt (D) and hex
nut (M). Tighten hardware.
• Slide the grip (Y) onto the release grip assembly (14).
M
STEP 11:
(SEE FIGURE 11)
• Slide the lift handle tube assembly (15) over the shaft
of the lift handle assembly (13)
13
Y
14
D
15
FIGURE 10
15
FIGURE 11
ATTACH THE CONTROL CABLE TO THE LIFT
HANDLE
STEP 12:
(SEE FIGURE 12)
• Insert the other end of the control cable (11) into the
bottom of the clevis lanyard fitting (U) and place the
cable into the groove as shown.
• Adjust the inner jam nut (J) approximately 3/4" from
the outer end of the threaded end
• Insert the control cable (11) into the tab (15a) on the
lift handle assembly tube (15) and tighten the two jam
nuts (J) on the control cable toward both sides of the
tab to secure.
• Secure the clevis lanyard fitting (U) to the lift handle
assembly tube (15) using a hex nut (I).
• Secure the clevis lanyard fitting (U) to the lift handle
assembly tube (15) using a hex nut (I). Tighten
hardware.
NOTE: Some adjustment of jam nuts may be required
after blade assembly is completed
I
U
11
10
U
15
11
15a
FIGURE 12
11