Publicidad
Idiomas disponibles
Idiomas disponibles
SPACER KIT ASSEMBLY INSTRUCTIONS
Depending on your mower, the included spacer kit may
be required to ensure the hitch mount assembly attaches
to your mower without interference. If you used the single
or double spacer assembly on this page, skip to the
instructions on page 7. If you don't need the spacers, start
assembly using the instructions on page 6.
SINGLE SPACER ASSEMBLY
• Place mounting bracket (3) flat onto zero turn front
frame. Open side of bracket facing up.
• Place the hitch mount assembly (1) on the mounting
bracket (3)
• Using two U-bolts (4) secure the hitch mount assembly
(1) with two mounting brackets (3), four washers (N),
and four hex nuts (K). Do not tighten.
• If the slider tube does not fully extend into both
U-bolts (4), then loosen the appropriate hex bolt (E)
and reposition the slider tube (2).
• Center the hitch mount assembly on the tractor frame.
• Tighten all hex bolts and hex nuts.
Note: Depending on your mower, U-bolts may need to be
installed at an angle.
K
N
3
2
4
3
1
E
DOUBLE SPACER ASSEMBLY
• Place mounting bracket (3) onto zero turn front frame.
Open side of bracket facing down.
• Place second mounting bracket (3) on top of the first
mounting bracket (3). Open side of bracket facing up.
• Place the hitch mount assembly (1) on the mounting
brackets (3)
• Using two U-bolts (4) secure the hitch mount assembly
(1) with two mounting brackets (3), four washers (N),
and four hex nuts (K). Do not tighten.
• If the slider tube does not fully extend into both
U-bolts (4), then loosen the appropriate hex bolt (E)
and reposition the slider tube (2).
• Center the hitch mount assembly on the tractor frame.
• Tighten all hex bolts and hex nuts.
Note: Depending on your mower, U-bolts may need to be
installed at an angle.
Mower Front Frame
Scan me for fitup chart!
5
1
3
4
Publicidad
