Agri-Fab 45-0613 Manual Del Usuario página 11

STEP 13:
(SEE FIGURE 13)
• Secure the control cable in two places along the shaft
of the lift handle assembly/lift handle tube assembly
(13/15) with nylon tie (W) as shown.
STEP 14:
(SEE FIGURE 14)
• Insert the bottom end of the blade pivot rod (12) into
the hole in the blade pivot shaft (10) and secure with a
hair pin (T).
• Insert the top end of the blade pivot rod (12) into the
hole in the lift handle tube assembly (15) and secure
with two hair pins (T).
10
12
T
15
13
11
W
13/15
FIGURE 13
12
15
T
13
12
FIGURE 14
11
ATTACH THE SKID SHOE
STEP 15:
(SEE FIGURE 15)
• Place a skid shoe (19) against the back of the blade
on one end of the blade assembly (18) and secure with
a two washers (O), two carriage bolts (B), and two hex
nuts (M). Tighten hardware.
• Repeat on the other end.
A
B
19
O
M
ATTACH THE BLADE EXTENSION
STEP 16:
(SEE FIGURE 16)
• Attach the wear plate (17) to the blade extension (16)
using two carriage bolts (A) and two hex nuts (M).
Tighten hardware.
• Attach the blade extension (16) to one end of the blade
assembly (18) using three carriage bolts (A) and three
hex nuts (M). Tighten hardware.
• Repeat on the other end.
16
17
M
A
18
A
B
19
O
M
FIGURE 15
M
M
A
FIGURE 16