Publicidad
Idiomas disponibles
Idiomas disponibles
Switching the device on / off
-
Press the main Switch.
Setting the working temperature set point
-
Touch the SET key (10). The LED (5) will flash.
-
Touch the keys (12) and (13) to adjust the temperature value.
-
Touch the key SET (10). The LED (5) will switch off.
-
To exit the procedure before the operation is complete, touch the ON key (11). Any changes will not be
saved.
3.4. Disconnection
Turn the equipment off verifying that the start-up warning lights are off.
In case of having the equipment off for a long period of time:
Turn off the main switch.
Disconnect from the power supply.
Clean the equipment carefully and dry.
Air the room periodically.
4. MAINTENANCE
4.1. General
This equipment has been designed for a maximum durability and high performance with minimum
maintenance. The correct performance and duration of the equipment will depend largely on a proper
maintenance according to the procedures described in this manual.
Avoid absolutely all abrasive or corrosive detergents as well as instruments such as steel sponges,
spatulas or metallic scrapers.
The hydrochloric acid and other chemical compounds contain chlorine and might damage the stainless
steel.
Before performing any cleaning operation, unplug the equipment and set the main switch on OFF or 0
position.
4.2. Cleanness
For the preservation of the equipment and the operating maintenance of the unit, it is advisable to follow these
steps:
Before connecting the equipment, clean the outer part of the furniture as well as the surface in contact
with the food using sanitary products.
At the end of the day:
Turn the main switch into OFF position.
Eliminate and clean all food scraps, if any.
Clean the surface with soap or non- abrasive detergent. Use a plastic spatula in case of having to
remove any stuck food scrap or mineral deposits.
Rinse with hot water to eliminate any detergent residues.
Clean the rest of the unit with non-abrasive products and dry.
Condenser:
The cleanness of the condenser must be done after unplugging the equipment and removing the
condenser unit .
7
EN
Publicidad
