Publicidad
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
WARNING:
The vibration and noise emissions during
actual use of the power tool can differ from the declared
values depending on the ways in which the tool is used
especially what kind of workpiece is processed; and Of the
need to identify safety measures to protect the operator
that are based on an estimation of exposure in the actual
conditions of use (taking account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle in addition to the trigger time).
PACKING LIST (FIG. A)
About recommended cutting line, please visit the website
egopowerplus.com or refer to the EGO Product Catalogue.
DESCRIPTION
KNOW YOUR LINE TRIMMER ATTACHMENT (Fig. A)
1. End Cap
2. Line trimmer Shaft
3. Line-Loading Button
4. Cutting Line
5. Trimmer Head (Bump Head)
6. Release Tab
7. Line-cutting Blade
8. Guard
9. Hex Wrench
WARNING:
Never operate the tool without the guard
firmly in place. The guard must always be on the tool to
protect the user.
ASSEMBLY
WARNING:
If any parts are damaged or missing,
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended for use with this
line trimmer. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possibly serious personal injury.
WARNING:
Do not connect to power head until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
MOUNTING THE GUARD
WARNING:
Always wear gloves when mounting or
replacing the guard. Be careful of the blade on the guard
and protect your hands from being injured by the blade.
Loosen and remove the two screws from the guard (Fig. C),
align the guard mounting holes with the assembly holes
and then lock the guard onto the shaft base with the two
screws, together with two spring washers (Fig. D).
Make sure the guard is fixed according to Fig. C & D, any
reverse fixing will cause great danger!
CONNECTING THE LINE TRIMMER ATTACHMENT TO
THE POWER HEAD
This line trimmer attachment is designed for use with EGO
Power Head PH1420E.
See " INSTALLING A POWER HEAD ATTACHMENT "
section in the power head PH1420E operator's manual.
OPERATION
WARNING:
Do not allow familiarity with this product
to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection, along with
hearing protection. Failure to do so could result in objects
being thrown into your eyes and other possible serious
injuries.
APPLICATIONS
You may use this product for the purpose listed below:
◾
Trimming grass and weeds from around porches,
fences, and decks
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use is deemed to be a case of misuse.
Before each use check for damaged/worn parts
Check the trimmer head, guard and front handle and
replace any parts that are cracked, warped, bent, or
damaged in any away.
The line-cutting blade on the edge of the guard can
dull over time. It is recommended that you periodically
sharpen it with a file or replace it with a new blade.
WARNING:
Always wear gloves when mounting or
replacing the guard or when sharpening or replacing the
blade. Note the location of the blade on the guard and
protect your hand from injury.
LINE TRIMMER ATTACHMENT — STA1600
EN
9
Publicidad
