Publicidad
Idiomas disponibles
Idiomas disponibles
PRELIMINARY INFORMATION
Mixers of the WAVE series are fit to operate with hot water accumulators under pressure, elec-
trical and gas instant water heaters.
WARNING: it is not possible to connect them to hot water accumulators without pressure (with
open circuit).
TECHNICAL DATA
- Minimum dynamic pressure ..................... 0,5 bar
- Maximum operational pressure /static) ......... 10 bar
- Recommended operational pressure (static).....1-5 bar
(N.B.: for pressure higher than 5 bar we suggest the installation of a pressure reducer)
- Maximum test pressure (static) ................... 16 bar
- Maximum hot water temperature ................. 80 ° C
- Suggested hot water temperature ................. 60 ° C (for energy saving).
BUILT-IN PARTS INSTAL-
LATION
- Rinse thoroughly the supply pipes.
- Connect the central connection (2) to
the taps through the threaded connec-
tions (1) using hemp or PTFE (Teflon)
for hydraulic tightness. WARNING:
do not make welds between taps and
connections.
- Screw the plug (3) on the central con-
nection (2) and assemble the protection
(4).
- Prepare an appropriate hole in the
wall and insert the tap in it with the
assembled protections: the installation
rates are shown in figure A (the built-in
depth allowed is intended at the wall
finished with coating).
- Open cold water and hot water sup-
plies and check the tightness of the sy-
stem (maximum test pressure : 16 bar
static).
- Finish the plaster and apply the co-
ating.
- GB -
RED STAMP: HOT
WATER
COMPLETE WALL IN-
CLUDING THE COATING
11
Publicidad
