Publicidad
Idiomas disponibles
Idiomas disponibles
The trimmer has not been charged at the factory. Please charge the trimmer for
2 hours before the first use for maximum performance. You can keep the trimmer
plugged into the adapter when not in use. The adapter will maintain the battery
at full charge and the green light will stay on. However, we recommend that the
adapter be unplugged if the trimmer won't be used for seven or more days.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Check to make sure adapter cord is plugged firmly into trimmer. Twist the adapter
connector slightly to insure good electrical connection. If failure to charge
still exists, return trimmer to Andis or an Andis authorized service station for
examination and repair or replacement.
USE WITH ADAPTER CORD
If the trimmer powers OFF in the middle of a trimming job, the power cord can be
attached to continue use in corded operation. When the trimmer is running with the
power cord attached, the green light will remain off, even if the battery is partially or
fully discharged. The trimmer will not charge while in use with the cord attached.
USING ATTACHMENT COMBS
Your trimmer may come with attachment combs (varies by unit, see Figure B). To use,
slide front of attachment comb over the teeth of the blade. Snap comb down over
back of blade (Figures C & D).
BLADES
When trimming is complete, slide ON/OFF switch to OFF position and remove the
attachment comb (if being used). Lightly brush out blades with the blade cleaning
brush provided. For best results put a drop of Andis Clipper Oil on the blade when
necessary. Motor bearings are permanently lubricated–do not attempt to oil. Blades
should be handled carefully and never bumped or used to cut dirty or abrasive
material.
5
Publicidad
