Descargar Imprimir esta página

Fagor 3FE-9214 Manual De Usuario página 100

Lavadora carga frontal
Ocultar thumbs Ver también para 3FE-9214:

Publicidad

Idiomas disponibles

Idiomas disponibles

7.3 Pump Filter
1
3
5
The pump filter system in your Washing
Machine prolongs the life of the pump
by preventing lint from entering your
machine.
We recommend that you clean the pump
filter every 2 months.
The pump filter is located behind the
cover on the front-lower right corner.
To clean the pump filter:
1. You may use the washing powder
spade (*) supplied with your machine
or liquid detergent level plate to open
the pump cover.
2. Lodge the end of the powder spade
or liquid detergent level plate in the
opening of the cover and gently press
backwards. The cover will open.
Before opening the filter cover, place
a container under the filter cover to
collect any water left in the machine.
Loosen the filter by turning
anticlockwise and remove by pulling.
Wait for the water to drain.
NOTE:
Depending on the
amount of water inside the machine, you
may have to empty the water collection
container a few times.
3. Remove any foreign materials from
the filter with a soft brush.
4. After cleaning, re-fit the filter by
inserting it and turning clockwise.
5. When closing the pump cover, ensure
that the mountings inside the cover
meet the holes on the front panel side.
6. Close the filter cover.
WARNING:
the pump may be hot, wait until it has
cooled down before carrying out any
2
cleaning or maintenance.
(*) Specifications may vary depending on
the machine purchased.
7.4 Detergent Drawer
4
The use of detergent may cause residual
build up in the detergent drawer over
time. We recommend that you remove
the drawer every 2 months to clean the
accumulated residue.
To remove the detergent drawer:
6
Pull the drawer forwards until it is fully
extended.
Press the region shown below inside
the detergent drawer you have pulled
all the way back, and continue pulling
and remove the detergent drawer from
its place
Remove the detergent drawer and
disassemble the flush stopper. Clean
thoroughly to completely remove
EN - 25
The water in

Publicidad

loading