Descargar Imprimir esta página

Garant GMT35 Manual De Uso página 38

Ocultar thumbs Ver también para GMT35:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 106
GARANT GMT35 Surface finishing machine
The operating company must ensure that personnel who work on the product comply with the regulations and provisions
de
together with the following instructions:
National and regional regulations for safety, accident prevention and environmental protection regulations.
No damaged products are assembled, installed or commissioned.
The necessary protective equipment is provided.
en
Instruct and train operators in the use of the machine.
Clearly specify personnel responsible for the various activities and check compliance.
Ensure limit values are not exceeded.
Regularly test safety devices for correct operation.
cs
3.7.
SAFETY DEVICES
Do not use the machine if it is damaged or the safety devices are not operational.
Before using the unit, always test the safety devices for correct operation.
In the event of unusual behaviour or hazardous situations, press the emergency stop switch immediately and report the
da
matter to a responsible person.
After the emergency stop switch has been actuated, secure the unit against being switched back on inadvertently until
the fault has been rectified.
After maintenance, cleaning or other activities, reactivate the safety devices and test them for correct operation
Do not remove, modify and bypass the safety devices.
es
3.8.
NOISE AND VIBRATION
i
The noise level generated is dependent on factors such as
the material and size of the workpiece, and the material of the abrasive,
fr
the sieve used,
and the finishing process concerned.
When the noise-absorption hood and the trough cover are both open, the noise level can rise to a value in excess of 79 dB.
As far as possible, always keep the covers closed (this reduces the noise by up to 10 dB). In particular when performing sep-
hr
aration (94 dB), hearing protection must be worn.
Abrasive process:
hu
Noise-absorption hood and the trough cover closed
Abrasive process:
Noise-absorption hood and the trough cover open
Separation process:
it
Noise-absorption hood and the trough cover open
* Information on measurement conditions:
Abrasive materials cylinder 15x30 mm
Motor speed 3000 rpm
nl
4.
Device overview
4.1.
ACCESSORIES
item
pl
Sieve
Scoop
Measuring jug
ro
Plastic insert for dividing wall
i
Transport trolley only for Article no.: 501305.
sl
38
Quantity
item
3
Aluminium dividing wall
1
Plastic dividing wall
2
Restraint
2
Emission sound pressure with abrasive ma-
terial and workpiece *
72 dB ± 2 dB
79 dB ± 3 dB
94 dB ± 3 dB
-
Quantity
1
1
2
-

Publicidad

loading

Este manual también es adecuado para:

501300501305