Publicidad
Idiomas disponibles
Idiomas disponibles
Stop Pins
Basket
Housing Cover
Pet Cock
Main
Housing
Gasket
Support
Screws
Assembly Instructions
1. Inspect all o-rings on the upper and lower stems and, if
worn, replace them.
2. Slide thrust washer on the upper stem. Lightly grease the o-
rings on the upper stem. Insert the upper stem into the main
housing from the upper ball area by pushing up through the
top hole. Insure that the rounded portion of the stem faces
toward the basket in the main housing.
3. Lightly grease the o-ring on the lower stem. Insert the lower
stem into the main housing from the lower ball area by push
ing up through the center hole. Insure that the flats on both
the upper and lower stems are in line and parallel with each
other.
4. Inspect the counterbores for the PTFE seats in the main
housing to insure that they are clean. Push the PTFE seats
into the counterbore making sure that they are flat and
parallel to the counterbore.
5. Slide the ball into the upper chamber keeping the solid side
of the ball facing the basket in the main housing.
6. Slide the ball into the lower chamber keeping the solid side
of the ball facing the basket in the main housing.
Diverter
Handle
Seats
Body
Studs
Main
Housing
O-rings
Balls
Knobs
Basket
Housing Cover
Upper Stem
O-rings
Thrust Washer
Upper Shaft
Lower Stem
Lower
Stem
O-ring
Seats
7. Inspect the main housing o-rings in the counterbore of the
ball chambers and replace if worn.
8. Inspect the counterbores for the PTFE seats in the basket
housing to insure that they are clean. Push the PTFE seats
into the counterbore making sure that they are flat and
parallel to the counterbore.
9. Verify that the balls are installed correctly and slide the
basket housing on to studs in the main housing. Install
lock washers and nuts and tighten the nuts in the proper
sequence.
10. Reinstall handle or gear operator on the main housing.
11. Inspect the o-rings on the baskets and replace if worn.
Insert the baskets in the counterbore in the basket
chambers.
12. Inspect the o-ring in the covers and replace if worn.
Assemble the covers on the basket housings and tighten
down with the knobs. See TABLE C for Knob torques.
13. Reinstall the drain plugs in both basket housings.
14. The unit is now ready for service. Follow the procedures
under Start Up instructions in this manual to place the unit in
service.
Pet Cock
Cover
O-ring
Basket
Basket
O-ring
Basket
Housing
Studs
Basket
Housing
Drain
Plug
Publicidad
