Makita HP457D Manual De Instrucciones página 4

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Drilling capacities
Fastening capacities
No load speed
Blows per minute
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2014
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for impact drilling in brick, brickwork
and masonry. It is also suitable for screw driving and
drilling without impact in wood, metal, ceramic and
plastic.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-1:
Model HP347D
Sound pressure level (L
Sound power level (L ) : 93 dB (A)
WA
Uncertainty (K) : 3 dB(A)
Model HP457D
Sound pressure level (L
Sound power level (L ) : 92 dB (A)
WA
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared noise emission value(s) may
also be used in a preliminary assessment of exposure.
Masonry
Steel
Wood
Wood screw
Machine screw
High (2)
Low (1)
High (2)
Low (1)
North/South America
Other countries
) : 82 dB(A)
pA
) : 81 dB(A)
pA
HP347D
10 mm
10 mm
25 mm
5.1 mm x 63 mm
216 mm
216 mm
D.C. 14.4 V
1.4 kg
D.C.14.4 V Model
D.C.18 V Model
DC18WA / DC18WB
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared val-
ue(s) depending on the ways in which the tool is used
especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-1:
Model HP347D
Work mode: impact drilling into concrete
Vibration emission (a
Uncertainty (K) : 2.0 m/s
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
4 ENGLISH
HP457D
13 mm
13 mm
36 mm
6 mm x 75 mm
M6
-1
0 - 1,400 min
-1
0 - 400 min
-1
0 - 21,000 min
-1
0 - 6,000 min
246 mm
239 mm
D.C. 18 V
1.7 kg
BL1415G / BL1420G
BL1815G / BL1820G
2
) : 9.0 m/s
h,ID
2
2
) : 2.5 m/s or less
h,D
2