ivoclar PrograScan PS7 Instrucciones De Uso página 13

3.2 Connection panel
The connection panel is located on the rear of the scanner and is laid out as follows:
1 Power switch
(24 V)
3.3 Power supply unit
NOTICE! Only use with the supplied power supply unit and power cable!
Otherwise guarantee regulations and product liability risks could be affected.
– Only use with the supplied power supply unit and power cable.
– Only connect the power supply unit to a socket with protected contacts.
Technical data of the power supply unit:
3.4 USB cables
NOTICE! Check the power of the USB cables.
Using two USB cables could result in lower performance.
– Connect the USB cables to two separate USB 3.0 ports. The full bandwith is required for each USB
cable.
Use the supplied USB cable. Should you use your own USB cable, make sure the following
requirements are complied with:
Shielded, full-featured 5 Gbit USB-C cable, maximum 1.4 m length. In the case of extensions over
1.4 m, use an active USB extension.
2 USB 3.0 port
(Master)
Manufacturer MEAN WELL
Type GST90A 24 – P1M
Input 90 ~ 264VAC
127 ~ 370VDC
47 ~ 63Hz
Power 90 W
Output 24 V, 3.75 A
3. Scanner overview and features
3 USB 3.0 port
13