OPERATING INSTRUCTIONS
Before using the battery powered shaver for the first time, charge the battery
continuously for 3 hours. Maximum battery capacity will only be reached after
3 charging and discharging cycles. A full charge will provide 4 hours of use.
ON/OFF SWITCH
To operate shaver, simply slide switch to the ON ("I") position. To stop operation,
slide switch to the OFF ("0") position. Make sure the switch is in the OFF ("0")
position when the shaver is not being used.
VERY IMPORTANT: Cutters must be cleaned on a regular basis for proper
functioning. Failure to regularly clean the cutters will void the warranty.
BASIC INSTRUCTIONS FOR USE
1. Men whose skin is sensitive or easily irritated by shaving, or who suffer from
a skin allergy, should test the shaver on one section of the leg or arm before
using it.
2. Remove the magnetic cap and turn on the unit to start shaving. Hold the shaver
at a right angle to the area that you want to shave and run the double shaving
foil carefully along your skin. Tip: In general, we recommend that you shave
against the direction of hair growth, as this is the best way to trim the hair.
Pull your skin tight with your fingers in inaccessible areas to achieve optimum
results.
3. Switch the shaver off each time after shaving and clean it.
4. Do not push the shaver on the skin too hard, as this could cause irritation, make
the shaver warm and prevent a perfect shave.
5. Please note that it takes 2 to 4 weeks for your skin to adapt to a shaver, so do
not change shaving instruments during this period of time.
6. If hair is longer than
/
", begin by cutting the hair down first with a trimmer,
1
32
then use shaver for a smooth, close shave.
FX79FS IB-18124A.indd 7-8
FX79FS IB-18124A.indd 7-8
7. This shaver is equipped with a foil head that pivots from side to side to help
the shaver head perform consistently over uneven skin surfaces. The pivoting
head can be locked to prevent it from pivoting if desired. To lock the pivoting foil
head, simply move the locking switch on the back of the shaver handle to the
lock position. To unlock, move the locking switch back to the unlock position.
Locking Switch
HIDDEN HANGING HOOK
The FX79FS has a sliding hanging hook that is built into the bottom of the unit next
to where the battery is removed and installed.
1. To use the hook, simply pull out with enough force to feel a click, which will lock
it in place.
2. When not using the hook, push it back into the base of the shaver, and it will click
into place, staying hidden until you want to use it again.
NEW Pivoting Foil Head with
Locking Feature
2023/10/17 6:07 AM
2023/10/17 6:07 AM