Publicidad
Idiomas disponibles
Idiomas disponibles
3. Leave head detached for drying.
4. Press the shaver head back into place
(see Fig. 4 on previous page).
5. Make sure the magnetic contacts on the cap are
clean, using alcohol to clean any debris or buildup.
NOTE: Always replace the cutters and foil head assembly at the same
time.
TO REPLACE FOIL HEAD ASSEMBLY
1. To remove the foil head assembly, hold the ribs of foil head assembly on
both sides and lightly pull up at one side and away from shaver body (see
illustrations below).
2. Take the replacement foil head assembly (FX79RF2G) out of package. Align
the replacement foil head assembly over the cutters. Carefully move the
replacement foil head assembly down toward the shaver unit until it firmly
snaps into place. BE CAREFUL NOT TO DAMAGE THE FOILS OR CUTTERS
WHILE INSTALLING.
FX79FS IB-18124A.indd 11-12
FX79FS IB-18124A.indd 11-12
TO REPLACE CUTTERS
1. First remove foil head assembly. Then remove one cutter by placing your
fingers on each side of it and gently pulling up and away from the drive
shaft. Repeat with second cutter.
2. Remove the new cutters (FX79RF2G) from the packaging. Align one cutter
above a drive shaft and lightly push down until it snaps into place. Repeat
with second cutter.
3. Replace the foil head assembly, then turn shaver on to ensure it is working
properly.
GOOD
BENT
Always check to be sure the cutters are not bent in any way.
BATTERY REMOVAL AND INSTALLATION
The FX79FS shaver features a removable, rechargeable, and interchangeable
battery, so you can cut and style for extended amounts of time with minimal
interruption. Be sure shaver is in the OFF ("0") position before removing or installing
the battery.
1. To remove the battery, press on the battery release button on the back of the
shaver handle toward the middle of the unit.
BAD
BENT
Battery Release Button
2023/10/17 6:07 AM
2023/10/17 6:07 AM
Publicidad
