Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Code
High LED
Flashes
Mid LED
Flashes
Low LED
Flashes
Hot & Warm
LEDs flash
Hot & Cool
LEDs flash
Hot & Cool
LEDs flash
Hot & Extra
High LEDs
flash
50 English
DC68-03850F-04_IB_WA3000A_EN.indd 50
DC68-03850F-04_IB_WA3000A_EN.indd 50
Your Washer has tried to fill but has not reached the proper water level.
NOTE
When the High LED is flashing, the washer drains for 3 minutes. During
this time, the POWER button is inoperative.
•
If the information code remains, contact a customer service center.
A fault is detected in the water level sensor.
If the information code remains, contact a customer service center.
Your washer is not draining. It can also mean that the unit senses a small
clog while draining.
•
Do the following:
1. Turn off the unit and turn it on again.
2. Select only the Spin Only.
3. Press the START/PAUSE to drain the water. If it still does not drain,
contact a customer service center.
Unbalanced load prevented your Washer from spinning.
•
Redistribute the load, and then press the START/PAUSE button.
Motor not running properly.
•
Restart the cycle by presssing the START/PAUSE button.
•
If the information code remains, contact a customer service center.
Mems sensor is not working properly.
•
If the information code remains, contact a customer service center.
Door lock is not working properly.
•
Close the lid tightly and restart the cycle.
•
If the information code remains, contact a customer service center.
Meaning
2023-06-23
2023-06-23
11:52:38
11:52:38
Publicidad
