Progress Lighting AirPro Edisto P2596-8130K Manual De Instalación página 10

Outlet box
Black (hot)
Black ("AC IN L")
Receiver
Black ("to motor L")
Blue (for light)
Blue (for light)
Black (motor)
Figure 13
7.
Finishing the Installation
Step 1. Tuck connections neatly into ceiling outlet
White (neutral)
box.
Green or bare
copper (ground)
White ("AC IN N")
Step 2. Slide the canopy up to mounting bracket and
place the key hole on the canopy over the screw on
the mounting bracket, turn canopy until it locks in
White
place at the narrow section of the key holes. (Fig.
("to motor N")
14)
Ground (green)
(Connect to ground
wire on hanger bracket
Step 3. Align the circular hole on canopy with the
if no house ground wire
remaining hole on the mounting bracket, secure by
exists.)
White (neutral)
tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
Make sure the notch on the hanging bracket properly
sits in the groove in the hanger ball before attaching
the canopy to the bracket by turning the housing until
WARNING
it drops into place.
Outlet box
Hanger
bracket
Canopy cover
Figure 14
Screws
Canopy