Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1
Removing the showerhead
□ Shut off the water at the main water supply. Remove the
existing showerhead using an adjustable wrench or pliers,
if needed.
□ Clean the threads on the shower arm.
□ Apply one to two wraps of thread seal tape (DD) onto the
threads of the shower arm in a clockwise direction.
3
Attaching the shower bar to the wall
□ Position the shower bar (G) vertically on the wall.
□ Remove the protective film from the adhesive pad (D) on
the diverter on the shower bar. Press the adhesive pad (D)
firmly to the wall.
NOTE: See option to mount with wall anchors on
Page 7.
D
DD
G
2
Attaching the shower bar to the
shower arm
□ Confirm a rubber washer (AA) is pre-inserted in the shower
arm connector (A).
□ Loosen the lock nut (B) and thread the shower arm
connector (A) onto the shower arm and hand tighten. Do
not overtighten.
B
4
Connecting the shower hose
□ Insert a rubber washer (AA) into the hose nut on the
shower hose (C). Thread the hose nut on the shower hose
(C) onto the bottom threads of the diverter on the shower
bar (G). Hand tighten, but do not overtighten.
□ Insert a rubber washer (AA) into the hose nut on the
remaining end of the shower hose (C). Thread the hose nut
onto the end of the handheld showerhead (F). Hand tighten,
but do not overtighten.
G
5
Please contact 1-855-HD-GLACIER for further assistance.
AA
A
B
AA
C
C
HOMEDEPOT.COM/GLACIERBAY
A
F
Publicidad
