Publicidad
Idiomas disponibles
Idiomas disponibles
Optional installation with wall anchors
1
Positioning the shower bar
□ Mark the location on the wall where the shower bar (G) will be
positioned.
□ Unthread the adhesive pad (D) from the connector at the
bottom of the shower bar (G).
□ Use the adhesive pad (D) to mark the drill hole locations
with a pencil.
G
D
3
Mounting the adhesive pad
□ Locate your marks on the wall and drill holes at the
locations.
□ Press the wall anchors (CC) into the drilled holes.
□ Secure the adhesive pad (D) to the wall using the mounting
screws (BB).
CC
WARNING: Fastening to shower substrates is a more permanent means of securing the shower bar to the shower wall. It is recommended
to contact a professional when attempting this method. Keep in mind that drilling holes is permanent, and impact to changing shower
products at a later date should be considered. There is risk of fastening to shower substrates without penetrating structural member, or
potential cracking or breaking of tile when not having proper working knowledge of the material. Avoid drilling into plumbing supply pipes,
normally positioned behind the wall, above the tub and shower valve.
G
D
D
D
BB
2
Preparing the shower bar
□ Remove the connector at the bottom of the shower bar (G) by
gently pressing the spring tabs inside the holes positioned on
each side of the connector.
□ Pull the connector away from the shower bar (G). You may
need assistance.
4
Securing the shower bar
□ Thread the connector from the shower bar (G) onto the secured
adhesive pad (D).
□ Snap the shower bar (G) back onto the connector.
D
7
Please contact 1-855-HD-GLACIER for further assistance.
G
G
HOMEDEPOT.COM/GLACIERBAY
Publicidad
