DeWalt DXV06PL Manual De Instrucciones página 7

2. When using the vac to pick up very ne dust, it
will be necessary to empty the dust tank and
clean or replace the lter at more frequent intervals
to maintain peak vac performance.
NOTICE:
A dry lter is necessary to pick up dry material.
If to use the vac to pick up dust when the lter is
wet, the lter will clog quickly and be very dif cult
to clean. If the lter gets wet, replace it before
continuing to do dry pickups.
INSTALLING THE CARTRIDGE FILTER
The cartridge lter can be used for wet or dry pick-up,
installation is the same for both.
1. With the power head in an upside down position,
slide the cartridge lter down over the lter cage,
push the lter seals against the power head.
2. Turn the knob on lter cage clockwise to
tighten the lter into place.
3. To remove the lter for cleaning, turn the lter
knob counter clockwise till feel the tactile and
auditory cue, and make sure the knob arrow
align with the "Unlock" icon on the lter cage,
then slide the cartridge lter off the lter cage.
then grasp the step of knob tightly with ngers
to pull the cartridge lter out off the cage.
4. To clean the cartridge lter, shake or brush off
excess dirt or rinse (from the inside of the lter)
with water, dry completely (approximately 24
hours) and re-install.
NOTICE:
If the lter has been used for wet pick-up, it must
be cleaned and dried before dry pick-up.
INSTALLING THE DISPOSABLE
FILTER BAG
1. Remove the power head of this vacuum by pulling
outward on the lid clips which is located on each
side of the vacuum, then lift the power head up.
2. Slide the cardboard collar opening rmly onto
the vacuum port de ector until it stops against
the de ector wall.
3. Position the bag so that it is distributed around
the inside of the tank.
4. Replace and secure the power head onto the tank.
Disposable
dust bag
WET PICK-UP
Remove all dirt and debris found in the tank. The
vacuum requires only a minimum of conversion when
going from dry to wet pick up. Remove the dry use
lter from the vacuum. A clean cartridge lter may be
used for vacuuming small amounts of liquids. For
best results when vacuuming large quantities of
liquid, remove the cartridge lter. When vacuuming
liquids containing debris, it is recommended to
purchase a foam lter and install over the lter cage.
The foam lter may be purchased by visiting our
website at www.dewalt.com, contacting our
customer service department, or purchasing at the
local D
amounts of liquid, it is recommend to remove the
cartridge lter. If the lter is not removed, it will
Lock
become saturated and misting may appear in the
exhaust.
At this time, you should dry or replace the cartridge
lter to eliminate the misting and possible dripping of
liquid around the lid.
Always shut off vacuum and disconnect the power
plug from the wall outlet before removing the
power head.
1. Place power head in an upside down position.
Remove the cartridge lter by sliding it up and off
the lter cage.
2. Shake excess dust off the cartridge lter with a rapid
up and down movement.
NOTE: WET PICK-UP ACCESSORIES SHOULD
BE WASHED PERIODICALLY, ESPECIALLY
AFTER PICKING UP WET, STICKY FLUIDS
OR SPILLS. THIS CAN BE ACCOMPLISHED
WITH A WARM SOLUTION OF SOAP AND WATER.
5
WALT distributor. When picking up large
E
WARNING:
ENGLISH