Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT:
To avoid damage to the impeller and motor,
always reinstall the Clean Connect™ lter before
using the vac for dry pickups and wet pickups.
IMPORTANT:
After cleaning, check the lter for tears or small
holes. Do not use a lter with holes or tears
in it. Even a small hole can cause a lot of
dust to come out of the vac.
Replace it immediately.
NOTICE:
Before installing the lter on the vac, clean the
area of the lid so that the lter will seal against
the lid and stop small particles from bypassing
the lter bag. If the lter is clean and not
damaged, replace it on the lter cage.
If it cannot be reused, place a new lter over
the lter cage.
NOTICE:
Clean the lter in an open area. Cleaning should
be done outdoors and not in living quarters.
CLEANING:
To keep the wet/ dry vac looking its best, clean
the outside with a cloth dampened with warm
water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and
mild soap.
3. Wipe out with dry cloth.
STORAGE:
Before storing the vac, the dust tank should
be emptied and cleaned. The cord should be
wrapped and hung on the unit and the
accessories should be kept in mesh bag so
they can be readily available. The vac should be
stored indoors.
TROUBLESHOOTING
Minor problems often can be xed without calling
customer service.
PROBLEM
Check power cord, plugs and outlet.
Motor does not run
Suction capacity
decreases
Thermal overload has been tripped:
1. Turn the vacuum off and
2. Empty the canister, if needed.
Vacuum stops
3. Allow the unit to cool.
running
4. Plug the power cord into an
Dust comes out
while vacuuming
7
SOLUTION
Ensure the on/off switch is in the
ON position( I )
Remove blockages in the suction
nozzle, suction tube, suction hose
or lters.
Replace the paper or eece dust bag.
Clean or replace the lters.
Empty the dust tank, refer to Empty
the tank under Operating
instructions.
disconnect vacuum cleaner from
power source.
(around 3-5 minutes).
appropriate outlet and turn on/off
switch to the ON position( I )to
test. If vacuum will not restart
call 1-888-899-0146
Check for proper installation of the
lters.
Ensure lters are not damaged;
replace if necessary.
Ensure lter seals are in place and
are secure.
ENGLISH
Publicidad
