Palmer PWT08MK2 Manual De Instrucciones página 4

USER MANUAL
PLEASE NOTE
Some effect devices are designed to operate in a voltage range of 9 to 18 volts and offer more dynamics and
headroom at a higher voltage. Be sure to read the user manual for your effect device to avoid damage.
This device may only be used in dry rooms.
INTRODUCTION
Power supply unit with 8 isolated DC voltage outputs for supplying power to effect devices. The output voltage
of outputs 7 and 8 is continuously adjustable from 6 to 18 volts. All DC voltage outputs are wired with the positive pole
on the outside and the negative pole in the centre.
PACKAGING CONTENT
Remove the product from the packaging and remove all packaging material. Please check the completeness
and integrity of the delivery and notify your distribution partner immediately after purchase if the delivery is not
complete or if it is damaged.
1× PWT08MK2 power supply

1× PW18VDCUNI 18 volt / 2000 mA DC power supply

8× DC cable 60 cm

1 set of self- adhesive rubber feet

User manual

EN
4