Publicidad
Idiomas disponibles
Idiomas disponibles
USER MANUAL
PWT08MK2
1
4
CONNECTIONS, OPERATING AND DISPLAY ELEMENTS
1. POWER INPUT
Orange-coloured low-voltage socket for supplying power to the device. Please use the original power adapter only
(included in the packaging content). The corresponding indicator LED lights up when the device is supplied with
the correct voltage.
2. DC OUTPUTS 1 - 6
Six isolated 9 V DC outputs with up to 300 mA output current each. All outputs have status LEDs. The correspon-
ding LED is deactivated if no DC cable is connected to the output. The LED of the corresponding output lights up
green when a DC cable is plugged in and the device is functioning correctly. In case of a fault, the LED lights
up red (e.g. short circuit, overcurrent, incorrect polarity). Once the fault has been rectified, the output can
be used normally again.
3. DC OUTPUTS 7 AND 8
Two isolated DC voltage outputs with an output current of up to 500 mA each and potentiometers for adjusting the
output voltage continuously from 6 V to 18 V. Always set the required voltage BEFORE connecting an effect device.
The two outputs each have a status LED. The corresponding LED is deactivated if no DC cable is connected to
the output. The LED of the corresponding output lights up green when a DC cable is plugged in and the device
is functioning correctly. In case of a fault, the LED lights up red (e.g. short circuit, overcurrent, incorrect polarity).
Once the fault has been rectified, the output can be used normally again.
4. MOUNTING HOLES
The housing of the power supply has mounting holes in the base plate for secure attachment to a pedalboard
or similar setup (e.g. with cable ties).
EN
2
3
4
Universal 8-way power supply unit for
effect devices
5
Publicidad
