Publicidad
Idiomas disponibles
Idiomas disponibles
connecting cable should only be carried out by our service department (see last page) or
by a qualified specialist (qualified electrician).
6 ADDITIONAL SAFETY INSTRUCTIONS FOR CROSS-CUT AND
TABLE SAWS
▪
Always wear eye protectors.
▪
Never use the equipment in the presence of flammable liquids or gases.
▪
NEVER use the equipment when a cutting disc (and not a saw disc) has been attached.
▪
Before each use, check the saw blade for small cracks or damages. Replace a cracked or
damaged blade immediately.
▪
Never use saw blades made of high-speed steel (HSS).
▪
Only use saw blades that are recommended by the manufacturer and that fulfil the EN847-
1 standard. Also make sure the riving knife is not thicker than the width of the saw cut, and
that it is not thinner than the body of the saw blade.
▪
Always use the accessories that are recommended by this manual.
▪
Select the correct saw blade for the material must be sawn.
▪
To reduce the generation of noise, always make sure that the blade is sharp and clean.
▪
Only use correctly sharpened saw blades. Never exceed the maximum speed that is
indicated on the saw blade.
▪
Before installing the saw blade, clean the axle, the flanges (especially the assembly
surfaces) and the hexagonal nut. Incorrect mounting can lead to vibrations/knocking or
slipping of the saw blade.
▪
Wherever possible, use the upper saw blade guard and the riving knife with every type of
application, also when sawing material in two. Always mount the saw blade guard
according to the instructions in this manual. Cutting operations are those where the saw
blade cuts completely through the workpiece, such as for instance when doing longitudinal
cuts or shortening workpieces. NEVER use the equipment with a defective saw blade
guard, and never tie up a saw blade guard with a rope or cord. Every irregularity in the
operation of the saw guard must be immediately corrected.
▪
Immediately replace the upper saw blade guard and the riving knife, after a process has
been completed that required their removal.
▪
Prevent that the saw comes into contact with metals, such as nails and screws. Search for
and remove all nails, screws and other foreign materials from the workpiece, before you
start to work.
▪
Remove spanners, cut off pieces and the other items from the saw table, before turning on
the switch.
▪
NEVER wear gloves while working; the wearing of gloves is only recommended while
cutting tools are being replaced.
▪
Make sure that your hands stay clear of the cutting line of the saw blade.
▪
NEVER stand in the cutting line of the saw blade and NEVER let anyone else stand in that
position.
▪
Make sure that the saw blade does not touch the riving knife or the workpiece, before you
turn on the switch.
▪
Let the saw run for a few moments before inserting a workpiece. Listen for vibrations or
knocking of the saw blade, which can indicate improper mounting or balancing of the
blade.
▪
The equipment may not be used for making grooves or recesses.
▪
Replace the table insert when it is worn out.
▪
NEVER make any adjustments on the machine while it is turning. Remove the plug from
the socket before making any adjustments.
▪
If necessary, use a push block. A push block MUST be used for longitudinal sawing of
smaller workpieces, so that your hands and fingers are kept well away from the saw blade.
▪
Always store your push block, whenever it is not in use.
Copyright © 2023 VARO
POWX07583
P a g e
| 6
EN
www.varo.com
Publicidad
