Descargar Imprimir esta página

VARO POWERPLUS POWX07583 Traduccion Del Manual De Instrucciones Originale página 61

Sierra de ingletes y de corte transversal con mesa alta
Ocultar thumbs Ver también para POWERPLUS POWX07583:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 85
11.10
Install vertical clamping device (Fig. 11)
Find out the vertical clamping device set (25).
Insert the iron bar of the vertical clamping device set into the back hole of the reference
ruler (13).
Adjustable Wing Screws to select height as required. Control the adjustable height of the
wing screw.
There are two round holes on the left and right sides behind the reference ruler (13), which
can be used to locate the vertical clamping device according to the work needs.
NOTE: Place the vertical clamping device on the right side of mitre saw
table when the machine is used to make bevel cuts.
11.11
Mounting the side extensions (Fig. 12)
Loosen right / left sides setscrew by turning it in a counter-clockwise direction using the
Hex key S5 (26) and remove setscrew away.
Insert the right / left side extension carrying handles (36) in the mounts provided on both
sides and tighten the setscrew by Hex Key S5 (26).
11.11.1
Connection to AC power
High-voltage!
Only operate this machine in dry surroundings.
This machine may only be connected to a power source that fulfils the following
requirements (also see the section "Technical data"):
− The mains voltage and the system frequency must conform to the voltage and frequency
that is indicated on the technical data sheet of the machine;
− Fusing protection with a residual current device (RCD), protects all lines from short-circuits
and overloading.
− Sockets must be properly installed, earthed and tested.
Position a power cable in such a way that it does not hinder the work and cannot be
damaged.
Protect the power cable against heat, aggressive fluids and sharp edges.
Only use rubber-coated extension cables with a sufficient wire cross-section (3 x 1.5
mm²).
Do not use the power cable for pulling the plug out of the socket.
12 OPERATIONS
This saw can be used as a:
Cross-cut saw/ miter saw
Table saw
Before making any changes in the settings of this machine, always remove
the plug from the socket.
Copyright © 2023 VARO
POWX07583
P a g e
| 11
EN
www.varo.com

Publicidad

loading