EINHELL TP-CC 10 T Manual De Instrucciones Original página 29

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols used (see Fig. 30)
1. Danger! - Read the operating instructions to
reduce the risk of injury.
2. Caution! Wear ear-muff s. The impact of noi-
se can cause damage to hearing.
3. Caution! Wear a breathing mask. Dust
which is injurious to health can be generated
when working on wood and other materials.
Never use the device to work on any materi-
als containing asbestos!
4. Caution! Wear safety goggles. Sparks ge-
nerated during working or splinters, chips and
dust emitted by the device can cause loss of
sight.
5. Caution! Risk of injury! Do not reach into
the running saw blade.
6. Using the supplied ring wrench, turn the disk
clockwise to release the table insert. Turn the
disk counter-clockwise to secure the table
insert against falling out.
7. To adjust the blade angle, swing the locking
lever downwards. To lock the blade angle,
swing the locking lever upwards.
8. Press in the overload cut-out in order to re-
lease the On/Off switch again.
9. When you fold the stop rail over the saw table
for narrow cutting widths, this will reduce the
actual cutting width by 5 cm compared to the
cutting width reading.
10. Conditions of the mains connection
11. Power rating
12. Speed
13. Cutting height at 90° and 45° blade angle
14. Blade dimensions
15. Thickness of the splitter
16. Weight
Anl_TP-CC_10_SPK13.indb 29 Anl_TP-CC_10_SPK13.indb 29
GB
1. Safety regulations
The corresponding safety information can be
found in the enclosed booklet.
WARNING!
Read all safety warnings, instructions, illust-
rations and specifi cations provided with this
power tool. Failure to follow all instructions listed
below may result in electric shock, fi re and/or
serious injury.
Save all warnings and instructions for future
reference.
2. Layout and items supplied
2.1 Layout (Fig. 1-29)
1. Saw table
2. Blade guard
3. Push stick
4. Blade
5. Splitter
6. Table insert
7. Parallel stop
8. Hand wheel
9. Locking lever for blade angle
10. Hole in the machine frame
11. On/Off switch
12. Overload switch
13. Rotary disk
14. Cross stop
15. Screw for blade
16. Extractor adapter
17. Extractor socket
18. Recess on the splitter
19. Fastening lever
20. Fastening plate
21. Slot in the saw table
22. Slot in the slide
23. Foldable stop rail
24. Guide rail for parallel stop
25. Main scale
26. Width extension scale
27. Locking bolt for the parallel stop
28. Guide screw for the parallel stop
29. Retaining screw for the parallel stop
30. 24 mm ring wrench
31. 20/24 mm combination wrench
32. 0° adjustment screw
33. 45° adjustment screw
34. Stop rail for the cross stop
35. Thumb screw for the cross stop
36. Locking screw for the cross stop
37. Button cover for the emergency stop switch
- 29 -
27.09.2023 08:10:02 27.09.2023 08:10:02