Publicidad
Idiomas disponibles
Idiomas disponibles
Control panel display
ICE button
Setting up your ice maker
Before using your ice maker
WARNINGS: Before plugging in your ice maker, wait four hours for the refrigerant fluid to
settle.
• Remove the exterior and interior packing.
• Remove all tape and take out the accessory parts from the unit. If any parts are
missing, contact customer service.
• Remove the "Pull" sticker from the bin handle.
• Clean your ice maker (see Cleaning your ice maker on page 9), then run two or
three cycles of ice and dispose of them to remove any plastic odor or residue
from the manufacturing and shipping process.
Finding a suitable location
• This ice maker is designed to be free standing only, and should not be
recessed or built-in.
• Place your ice maker on a counter top that is strong enough to support it
when it is fully loaded.
• Allow six inches (15 cm) of space between the back and sides of the ice maker
and any surrounding walls to allow for proper air ventilation.
• Place the ice maker away from direct sunlight and sources of heat, such as a
stove, heater, or radiator. Direct sunlight may affect the acrylic coating and
heat sources may increase electrical consumption. Extremely cold
temperatures may also prevent the ice maker from performing properly.
Providing a proper power supply
Improper use of the grounded plug can result in the risk of electrical
WARNINGS:
shock. If the power cord is damaged please call our customer service.
This appliance requires a standard 110-120V, 60Hz electrical outlet with good
grounding means.
This unit should be properly grounded for your safety. The power cord of this
appliance is equipped with a grounding plug which mates with standard
grounding wall outlets to minimize the possibility of electric shock.
www.insigniaproducts.com
Portable Nugget Ice Maker
LIGHT
button
5
Publicidad
