Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
WARNING:
the snow blower before cleaning or performing any maintenance.
WARNING:
parts may create a hazard or cause product damage. To ensure safety and reliability, all repairs
should be performed by a qualified service technician.
NOTICE:
Periodically inspect the entire product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
penetrating oils, etc. come in contact with plastic parts. Chemicals can damage, weaken, or
destroy plastic which can result in serious personal injury.
LUBRICATING THE MACHINE
All of the bearings in this product are lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions. Therefore, no further
bearing lubrication is required.
REPLACING THE SCRAPER BAR
WARNING:
off the bail switch and remove the
battery pack(s) before performing any
maintenance task on your snow blower.
1. The scraper bar is located at the
bottom of the snow blower beneath
the auger (Fig. 23).
26
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2110/SNT2110-FC
To avoid serious personal injury, always remove the battery pack(s) from
When servicing, use only identical replacement parts. Use of any other
Do not at any time let brake fluids, gasoline, petroleum-based products,
Make sure to turn
23
Scraper Bar
Publicidad
