GE GFWN1100 Manual Del Propietario E Instalación página 17

Installation Instructions
UNPACKING THE WASHER
A, WA RNING: Recycle or destroy the
carton
and plastic bags after the washer is unpacked. Hake
materials inaccessible to children. Children might use
them for play. Cartons covered with rugs, bedspreads
or plastic sheets can become airtight chambers causing
suffocation.
1. Cut and remove the top and bottom packaging straps.
2. While it is in the carton, carefully lay the washer on its
side. DO NOTlay the washer on its front or back.
3. Turn down the bottom flaps-remove all base packaging,
including the cardboard, styrofoam base and styrofoam
tub support (inserted in center of base).
NOTE:If you are installing a pedestal, proceed to
the installation instructions that come with the pedestal.
4. Carefully return the washer to an upright position and
remove the carton.
5. Carefully move the washer to within 4 feet (122 cm)
of the final location.
6. Remove the following from the back side of the washer:
/4bolts
/4plastic spacers (including rubber grommets)
4 power cord retainers
/
NOTE:Failure to remove the shipping braces can cause
the washer to become severely unbalanced.
Save all bolts for future use.
NOTE:If you must transport the washer at a later date,
you must reinstall the shipping support hardware to prevent
shipping damage. Keep the hardware in the plastic bag
provided.
In caseyou misplace your shipping bolts, replacements
are available at additional cost. They can be ordered in the
United States by visiting our website at GEAppliances.com
or calling 800.GE.CARES. In Canada, call 800.661.1616.Order
kit #WH49×10039.
17