AQUA SPHERE 75947 Manual De Instrucciones página 8

4. CONNECTING TO POOL PUMP
Please follow these steps and the wiring diagram for correct connection.
The warranty may be compromised if the device is not installed in
accordance with instructions de scribed in this manual.
Only ONE pump can be connected to the inverter. Please do not
connect any other appliance to the output.
Mark the hole locations on the wall, drill and insert the expansion plugs
supplied, fit the screws and hang the device on the screws.
4.1 Turn off all electrical supply to the pool pump, unplug it from the main
switch or at the chlorinator which provides electrical power to the pump.
4.2 Plug the pool pump into the device´s power outlet (marked PUMP
CONNECTION ONLY).
It is recommended that the total length of the equipment output line and
the swimming pool pump power line shall not exceed 2m.
4.3 Plug the device into the main switch/chlorinator/timer connection where
the pump was originally plugged into.
4.4 In order to reduce the impact of electromagnetic interference; please
connect the grounding wire, that´s fixed on the heat sink, to the pool pump
motor (if the output of frequency inverter does not have a plug, it does not
need to be connected)
4.5 Switch all power back on.
4.6 Ensure chlorinator/timer is active.
4 . 7 Now the device is ready to operate
6