MoMi GISELLE 2w1 Manual De Usuario página 15

O. Basket
P. Brake
Q. Carrycot
ACCESSORIES:
U. Cup holder
V. Mosquito net
W. Rain cover
PRODUCT ASSEMBLY AND FUNCTIONS:
1. Pull the folding buttons, then lift the handle until you hear a clicking sound; it means that the frame
has been unfolded correctly.
2. Insert the front and rear wheels into the corresponding holes in the frame. The clicking sound
indicates that the wheels are correctly seated.
3. To remove the front wheels, pull the quick-release button, which is located under the footrest in the
frame.
4. There is a steering lock of the front wheels on the back. To lock the steering of the front wheels,
move the lock.
5. To remove the rear wheels, press the quick-release button, which is located under the brake axle.
6. To change the height of the push handle, press the buttons located on both sides of the handle, and
then adjust the height of the handle until you hear a clicking sound.
7. To remove the seat or carrycot from the frame, press the buttons located on both sides of the seat
or carrycot.
8. This stroller is equipped with a foot parking brake on the rear axle. Press the brake pedal downwards
so that the brake is activated. Unlocking takes place after lifting the pedal up.
STROLLER FUNCTION:
1. Grasp the backrest adjustment button and raise the seat back.
2. Insert the seat into the appropriate holes in the frame, forward- or rearward-facing.
3. To install the safety bar, grasp it with both hands and direct it to the connectors located on both sides
of the seat. Push the headband into the connectors until you hear a click. To remove the headband,
press the buttons located on the sides of the headband.
4. To unbuckle the seatbelts, press the button that is located on the crotch belts buckle. The seatbelts
can be adjusted to fit the child properly; however, be careful that the child is not squeezed too tightly
and can breathe freely. When fastening the belts, make sure that the baby's hands are not near the
buckle.
WARNING!: Always use the restraint system.
5. The seatbelts have a 3-stage height adjustment. To change the height, lay the seat forward, then
release the buckle by sliding it out from under the backrest with one hand and pulling it out with the
other. Choose the height at which you want to install the belt, then put the buckle through the hole
in the coating and pull it through the backrest until it locks into place on the back of the seat.
Note: Check that the belt is properly locked on the back of the backrest.
6. To adjust the footrest, press both adjustment buttons, which are located on both sides of the seat,
and push the footrest down. To raise the footrest, just pull it up without using the buttons.
EN
R. Mattress
S. Leg cover for the carrycot
T. Leg cover for the stroller
X. Bag for the parent
Y. Universal car seat adapters
15