Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
AMPLIFIER/ HI FI CONNECTION (if required)
LINE OUT
Whilst you can listen to your new turntable using the built in speakers you may wish to connect it to your existing Hi Fi
system. Connect the output audio plugs to the Line input on your mixer or amplifier using an RCA cable (not supplied).
TURNTABLE
1. Place the record of your choice on the turntable. If required, do not forget to place the adaptor on the record
spindle;
2. Choose the desired playing speed using the speed selection switch between 33, 45 and 78rpm.
3. Turn on the Rotary Power Switch (8), note that this also controls volume;
4. Release the tone arm lock and raise the arm with your hand lightly;
5. Place the stylus vertically over the first track of the record, the turntable will start turning automatically;
6. Put down the stylus slowly on to the record to play;
7. When a record comes to the end, the turntable will stop automatically if the auto-stop switch is in the ON position.
If the switch is in the off position then it will keep revolving until the tone arm is returned to the tone arm rest;
8. Lift up the tone arm and put it on the rest when finished;
9. Replace the protective cap on the stylus, close the tone arm lock; and Turn off power at mains.
NOTES:
-
Remove the turntable cap before use.
-
Make sure that the arm is locked by the lock before and after use.
- Some discs may stop before the end, as the disc area does not match the settings of this unit. In this case, set the AUTO
STOP selector switch (5) to OFF. In this way, the disc will play back to the end but will not stop automatically.
ADVICE:
-
We advise you to clean your records with an anti-static cloth to gain maximum enjoyment from them and to
make them last.
-
We would also point out that for the same reason your stylus should be replaced periodically (approximately
every 250 hours).
-
Dust the stylus from time to time using a very soft brush dipped in alcohol (brushing from back to front of the
cartridge).
HEADPHONE
Insert the headphone jack into the socket (9), the speakers will be disabled.
AUX-IN
Connect a cable with a 3.5mm jack plug to the AUX IN socket (13) and the other end to the external device.
TECHNICAL FEATURES
Power supply:
Power consumption:
Audio power:
Dimensions:
Precautions for correct disposal of the product.
The symbol shown on the equipment indicates that waste must be disposed of in "separate collection" and so the
product must not be disposed of together with urban waste.
The user must take the product to special "separate waste collection centres" provided by local government, or deliver
it to the retailer against the purchase of a new product.
Separate collection of waste and subsequent treatment, recycling and disposal operations promotes the produc-
tion of equipment with recycled materials and limits negative effects on the environment and on health caused by
improper handling of waste.
Illegal disposal of the product leads to the enforcement of administrative penalties.
..................................................
..................................................
..................................................
..................................................
5V
1A
4,5W
2x 3W
355x 285x 127mm (L x W x H)
7
TT 1015
Publicidad
