Cembre SD-36B Manual De Uso Y Mantenimiento página 20

Before servicing or maintenance of the drilling machine, always remove the battery
Daily maintenance is indispensable to keep the machine in best condition. Maintenance not car-
ried out properly, or carried out by unauthorised or unqualified personnel can noticeably reduce
the machine's efficiency and increase the risk of accidents and serious injury. The maintenance
procedures described may be carried out by the operator.
For any eventual fine tuning or repairs, return to CEMBRE (Ref. to § 11).
8.1) ORDINARY MAINTENANCE OF THE DRILLING MACHINE
Daily
Before use, check:
The drill in its entirety (securing of various components).
The correct operation and integrity of the motor switches.
The integrity and charge of the batteries.
Check the Integrity of the rainproof cover (10) band the absence of cuts or abrasions, if dama-
ged the cover must be immediatly replaced.
After use:
Clean the machine of any contaminants and swarf by using a clean rag.
Thoroughly clean the spindle area and the drilling machine of any swarf.
Clean the air inlets on the side of the motor if they are clogged.
Every 5 hours of operation
8.1.1) Checking screws
Check and re-tighten all screws where necessary.
Every 50 hours of operation
8.1.2) General verification
Check all functions of the drill.
8.1.3) Lubrication
(Depending on ambient conditions and use) periodically lubricate the return spring shafts,
proceeding as follows:
Remove the detachable guard PRM-UN and the springs (4).
Carefully wipe the two shafts using a clean cloth soaked in kerosene.
Lubricate the two shafts with a few drops of oil, ensuring a uniform distribution of the oil.
Re-assemble the two springs and detachable guard.
8.1.4) Routine maintenance Routine maintenance
When the drilling machine reaches the predetermined number of
hours worked, it will signal on the display that routine maintenance
is recommended. The machine continues to work however, it is recom-
mended that it is sent to CEMBRE for a complete overhaul (see § 11).
8. MAINTENANCE
Errori
S/N 24AX02
FW S1K848..
100
SD-36B
S/N 24AX02
.
FW S1K848..
100
SD-36B
S/N 24AX02
FW S1K848..
100
SD-36B
!
S/N 24AX02
FW S1K848..
003
100
SD-36B
S/N 24AX02
FW S1K848..
DRIVER
100
SD-36B
S/N 24AX02
FW S1K848..
MOTOR
100
SD-36B
A
S/N 24AX02
FW S1K848..
MOTOR
100
SD-36B
NTC
S/N 24AX02
FW S1K848..
FAULT
100
SD-36B
S/N 24AX02
FW S1K848..
100
20