Allen + Roth WSWS-CS1C Manual Del Usuario página 8

ASSEMBLY INSTRUCTIONS
Wall Hanging Installation
21. Using a stud finder, locate the edges of the wood
studs. Find the center line of each stud and draw a
vertical reference line on the wall over each one. Position
installation template (W) at desired location on wall.
Note: The bottom of the installation template (W) should
be no less than 31-1/2 in. from the floor.
Mark mounting holes with a pencil (not included) and
discard installation template (W). Drill 3/16 in. pilot holes at
marked locations. Then, with the beveled edge facing up,
attach the wall hanging cleats (O) with large flat washers
(QQ) and lag bolts (PP).
Hardware Used
M8 x 2-1/2 in. Lag Bolt
PP
QQ Large Flat Washer
22. With the help from another person, carefully
hang the unit onto wall hanging cleat (O).
21
16 in.
O
39-1/2 in.
W
O
Minimum 31-1/2 in.
x 4
x 4
22
O
O
O
14
ASSEMBLY INSTRUCTIONS
Long Shelf Installation
Note: If long shelf (V) needs cut to fit inside your closet
space, cut only one side of the shelf and do not use
QQ a hacksaw. It is recommended you hire an insured
remodeler for this type of installation.
PP
23. With a pencil, draw a level line at the desired
mounting location for long shelf (V). Using L-brackets
(SS) as a guide, mark the screw hole locations with a
pencil. Drill 3/8 in. diameter pilot holes at least 2-1/2 in.
deep at marked locations, then insert wall anchors
QQ
into the holes until they are flush with the wall. Attach
L-brackets (SS) to the wall using M4 x 38 mm screws
PP
(KK) and to the long shelf (V) using M4 x 14 wood screws
(MM).
Hardware Used
KK
M4 x 38 mm Screw
MM
M4 x 14 mm Wood Screw
RR Wall Anchor
SS
L-Bracket
24. Attach long shelves (V) to hutch panel left (A)
and hutch panel right (B) with L-brackets (SS),
securing with M4 x 14 mm wood screws (MM).
Hardware Used
MM
M4 x 14 mm Wood Screw
SS
L-Bracket
23
V
(RR)
KK
MM
x 8
x 8
x 8
x 4
24
SS
x 16
x 4
15
RR
SS
V
MM