Publicidad
Step 1
å
Assemble your unit on a carpeted floor or on the empty carton to avoid
scratching your unit or the floor.
å
Fasten the BRACES (B) to one of the ENDS (A) as shown. Turn two 1/2"
HEX HEAD SCREWS (3) a few turns using the L-WRENCH (1). Do not
completely tighten the SCREWS at this time.
1
1/2" HEX HEAD SCREW
(2 used in this step)
Page 4
The tabs must face each other.
B
3
www.sauder.com/service
B
A
WARNING
Do not completely tighten
bolts and screws until you
have completed assembly.
3
429541
Publicidad
