Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical Connection
WARNING
ELECTRICAL SHOCK HAZARD.
WARNING
TURN OFF POWER CIRCUIT AT THE SERVICE PANEL
BEFORE WIRING THIS UNIT.
120 VAC, 15 OR 20 AMP CIRCUIT REQUIRED.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION
BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW)
SERVES TO GROUND THE APPLIANCE. TO PROTECT YOU
AGAINST ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE GROUNDING WIRE IN
YOUR HOME ELECTRICAL SYSTEM, AND IT MUST UNDER
NO CIRCUMSTANCES BE CUT OR REMOVED.
Failure to do so can result in death or electrical shock.
• Remove the knockout and the Junction box cover and install
the conduit connector (cULus listed) in junction box.
A
• Run 3 wires; black, white and green ,according to the National
Electrical Code and local codes and ordinances, in 1⁄2" conduit
from service panel to junction box.
A
B
C
D
F
E
• Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
• Close and secure junction box cover.
Complete installation
Replace filters.
Check operation of the hood.
If range hood does not operate:
• Check that the circuit breaker is not tripped or the house fuse
blown.
• Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read the
"Maintenance" section.
Keep your Installation Instructions and Use and Care Guide close
to range hood for easy reference.
A.
Knockout
B.
Junction box cover
B
A. White wires
B. Black wires
C. CUL listed wire connector
D. Yellow-green (or bare)
ground wire
E. Homepower supply cable
F. UL listed or CSA approved 1⁄2"
strain relief
Description of the hood
1
2
3
1 Blower and light controls
2 LED lamps
3 Grease filter handle
4 Grease filter
Control
1
2
3
1 Button ON/OFF motor (stand by)
2 Button for low speed (suction power) selection
When flashing, it indicates that you must wash the grease filter.
3 Button for medium speed (suction power) selection
4 Button for high speed (suction power) selection
5 Button for intensive speed (suction power) selection
It lasts 5 minutes then it returns to medium speed (suction
power).
6 Button ON/OFF lighting
Press briefly to switch on or off the lighting of the hood.
Press and hold to adjust the intensity of the light.
Indicators of filter saturation:
At regular time intervals, the hood indicates the need of
performing filter maintenance.
Button
on with steady light:
Perform grease filter maintenance.
Button
flashing:
Perform activated charcoal filter maintenance.
NOTE: Filter saturation signal is visible within the first minute after
switching off the hood; within this time, the reset of saturation
indicators must be performed.
Reset of filter saturation indicators:
Press and hold the button
Activation of saturation indicator activated charcoal filter:
NOTE: This operation must be performed with the hood off.
This indicator is normally deactivated; press and hold the button
to activate the function: the button lights up with steady light.
To deactivate the function, press and hold the button
button lights up flashing.
3
4
4
5
6
, the
9
Publicidad
