Publicidad
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Flow rate - 34960xx1
tub filler
handshower
Flow rate - 39451xx1
tub filler
handshower
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
This trim is for use with rough valve
10452181 (not included).
• This unit is not anti-scald. If required by local code,
install in combination with an approved remote
pressure balance valve or other approved device.
• Protection against backflow is provided by a check
valve and by an automatically resetting diverter.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
5.8 GPM (22 L/min) @ 44 PSI
max. 1.75 GPM (6.6 L/min)
5.8 GPM (22 L/min) @ 44 PSI
max. 2.0 GPM (7.6 L/min)
• 34960xx1 only: This showerhead is for use
with an automatically compensating valve rated at
1.3 GPM (4.9 L/min) or less.
• 39451xx1 only: This showerhead is for use
with an automatically compensating valve rated at
1.5 GPM (5.7 L/min) or less.
• To prevent scald injury, the maximum output
temperature of the shower mixing valve must be no
higher than 120°F. In Massachusetts, the maximum
output temperature can be no higher than 112° F.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicidad
