Silvercrest SSRM 10 A1 Manual De Instrucciones página 46

SilverCrest SSRM 10 A1
You can also keep the "-" button (2) or "+" button (4)
pressed to fast forward or reverse the numbers.
Finally, press the "MODE" button (3) again. The set time is now
indicated on the display (1).
If you have selected the 12-hour format, the hours before noon
(AM) or hours after noon (PM) are indicated on the display (1).
Switching on / off
Briefly press the "On/Standby" button (6) to switch on the scan
radio. "ON" is indicated briefly on the display (1), followed by
the frequency currently set.
Briefly press the "On/Standby" button (6) again to switch off the
scan radio. "OFF" is indicated briefly on the display (1), followed
by the time currently set.
Setting the volume
You can set the device volume to a value between "00" (mute)
and "15" (maximum volume). The setting upon delivery is "03".
Proceed as follows:
Press the "-" button (2) or "+" button (4) in radio mode to
decrease or increase the volume. The "VOLUME" indicator (21)
also appears on the display.
If the volume reaches level "04", the volume warning symbol
(17) starts to flash on the display. Now you can continue to
increase the volume only if you have confirmed the volume
44 - English