Publicidad
Idiomas disponibles
Idiomas disponibles
5 - Element and Control Setting
EN
Control knobs and power level adjusting
The placement of each knob corresponds to the placement of the induction element that it controls.
To turn on any, PUSH and TURN the knob clockwise to the required setting, of the according cooking zone can be increased
between a minimum of 1 to a maximum of 9. To reduce the power of the cooking zone again it is necessary to turn the knob
anticlockwise.
The current power level is displayed on the display unit of the hob.
Timer function setting
NOTE: the timer is only intended as an acoustic advisor that recalls the attention of the user.
Timers have no effect on the heating elements. Cooking zones must always be stopped manually by rotating the knob in
the corresponding [OFF] position.
It's possible to set the timer from 1 to 9h59 minutes: it beeps when the time has run out. This function is always available and is
indicated by the clock symbol "H" which is located in the middle of cooktop above the power setting displays.
Timer setting
• Push the Timer knob until "H000" appears, the first two digits H0 start to blink, turn the knob left/ right in order to set the timer
value (Hour), press the knob again to set the minutes following the same procedure, confirm the timer value by pressing the
knob.
• Pushing the knob before the time is expired is possible pause it (P is displayed), then restart it by pressing the knob again.
• To delate the timer setting keep pressed the knob for about 3 second until the display value disappears.
8
ELEMENT AND CONTROL SETTING
TIMER FUNCTION (FOR 36" ONLY)
Publicidad
