Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
4
Wrapping the extra wire
NOTE: Follow this step ONLY if you did not cut the extra length off
from the wires coming from the ceiling fan.
□
Gently wrap the excess wire around the slide-on mounting
bracket (A).
□
Secure with electrical tape.
5
Mounting the fan motor assembly
(standard mount)
□
Align the locking slots of the ceiling canopy (C) with the two
A
screws (MM) in the slide-on mounting bracket (A). Push up to
engage the slots and turn clockwise to lock in place.
□
Firmly tighten the two mounting screws (MM).
C
□
Install the two mounting screws (saved from Assembly Step
1 "Prepairing for mounting") into the holes in the canopy (C)
and tighten firmly.
FF
D
E
10
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
NN
MM
FF
Publicidad
