Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Attaching the Lights
1
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
NOTE: Notice the location of the fan's slide switch. This is
the switch used to change the fan's directional rotation.
For more information on the operation of this switch, see
Operating Your Fan on page 13.
□
Remove the three screws (VV) on the switch cup cover of the
light kit fitter assembly (H).
□
Connect the wires from the light kit fitter assembly (H) to the
wires from the switch cup of the fan motor assembly (E) by
connecting the molded adaptor plugs together (blue to black,
white to white). Carefully tuck all wires and splices into the
switch cup.
□
Align the three holes in the switch cup cover of the light kit fitter
assembly (H) with the three holes in the switch cup of the fan
motor assembly (E). Make sure the notch in the switch cup cover
of the light kit fitter assembly (H) clears the reversing switch
in the switch cup of the fan motor assembly (E). Position the
light kit fitter assembly (H) and re-install the three screws (VV)
that were removed in the first step to secure the light kit fitter
assembly (H).
□
Attach the pull chains (EE) provided to the light pull chain and fan
pull chain.
2
Installing the bulbs
CAUTION: Make sure the power is off before attaching or
removing the LED bulb.
□
With the power off, install the two LED bulbs (I) by screwing
them into the light bulb sockets.
12
E
VV
H
EE
I
Publicidad
