Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Pull off the canopy bottom cover (FF) from the canopy (C).
□
Loosen the two canopy screws (HH) located in the bottom of
the slide-on mounting bracket (A), and turn the canopy counter
clockwise to remove the slide-on mounting bracket (A) from
canopy (C).
HH
3
Assembling the fan
WARNING: Failure to properly install the locking pin (DD)
could result in the fan becoming loose and possibly
falling.
□
Loosen, but do not remove, the set screws (JJ) on the collar
on top of the fan motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan motor
assembly (E).
□
Carefully insert the hanger pin (CC) through the holes in
the collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (CC) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the set screws (JJ) on the collar on top of the fan
motor assembly (E).
2
□
□
A
C
FF
7
Routing the wires
Route the wires exiting the top of the fan motor assembly
(E) through the decorative motor collar cover (D) and then
the center of the canopy bottom cover (FF). Make sure
the opening of the canopy (C) is on top and insert the ball/
downrod assembly (B) through the canopy (C).
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
DD
Please contact 1-855-HD-HAMPTON for further assistance.
C
B
FF
D
E
B
CC
JJ
E
HAMPTONBAY.COM
Publicidad
