Publicidad
Assembly
• The air compressor is used to supply energy to pneumatic tools as versatile as power tools are. The tools
can be used to drill, screw, hammer, rivet, staple, chisel, polish, blowtorching, cleaning, painting etc.
• The compressor functions are completely automatic and controlled with the pressurestat. It stops the motor
when the tank's pressure has reached the maximum level. It starts again when the level goes down to a level
lower to 551 kPa (80 PSI).
• The compressor shall be connected into an outlet protected with an adequate differential switch
(thermal-magnetic).
A
• Carefully lay down the compressor onto a flat, leveled
and solid surface to assemble the wheels (A) and the
front supports (B) with their screws and hex nuts as
shown in the illustration.
• Set the compressor up and screw on the air filter (C) on
one side of the carter as indicated in the illustration.
C
B
7
ENGLISH
Publicidad
