Phocos CIS-N-LED Serie Manual De Instrucciones página 20

contains information regarding installation, set up, and operation.
When installing or working on the PV system, please disconnect the PV (solar) modules from
the charge controller first, to prevent any damages to the charge controller!
Please verify that all cable/wire connections are done properly and well insulated and that no
water or humidity can ingress. This avoids any bad or loose connections that would result in
excessive heating or further damage.
Please install a fuse or breaker near the battery before installing or adjusting the controller!
Never touch any electrical conductors in order to avoid electrical shock.
Never work on live (energized) electrical equipment.
When working around a battery, do not allow tools to bridge the battery terminals, or short
circuit any part of the battery.
Use only tools with insulated handles.
Operation of this device may produce high voltage which can cause severe injuries or death in
case of improper installation or operation of the device.
PV modules can generate high DC voltages!
Make sure the cables are always connected to the correct terminal. An electrical shock can be
lethal. In general, any electric shock can be dangerous to your health.
18