THERMEx Sirocco Instrucciones De Montaje página 45

4. Release pause key.
Ÿ
'U' is flashing alternately with a number '0' on
the cooking zone display on the rear left.
Ÿ
The configuration value appears in the
cooking zone display on the front left.
5. Touch the cooking zone key on the rear left
and choose the correct number of the menu
code (see table).
Menu code Description
U2 Volume key sound
U3 Volume alarm signal
U4 Lighting level display
U5 Countdown animation (on or off)
U6 Pan detection (on or off)
U7 Audio signal countdown timer
11. POWER LIMITER

Setting the power limiter should only be
carried out by a registered and qualified
installer. Please read the safety regulations
and the installation instructions carefully.
The hob is equipped with a power limiter. If the
total power of operating cooking zones exceeds
the maximum available amount of power, the
power is automatically reduced. The display of
the cooking zone who is being reduced in its
power is first flashing; the level is then
automatically reduced to the highest available
power.
Ÿ
The limiter is set at 7400W by the factory,
but it is possible to change it to 2800W,
3500W or 4500W.
6. Touch the cooking zone key on the front left
and select the correct value (see table).
7. Confirm the setting; touch and hold the
on/off key until you hear an audio signal.
Configuration value
0 - 1 - 2 - 3
0 - 1 - 2 - 3
Max. 0 - 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 Min.
0 - 1
0 - 1
0 - 1 - 2
Power limiter configuration
Make sure there are no pots or pans on the hob
before you start!
1. Disconnect the appliance from the main
power supply by removing the power connector
from the socket, by removing the fuse or turning
the circuit breaker off.
2. Reconnect the appliance to the power
supply.
Ÿ
The keep warm key is flashing.
Ÿ
Perform, within 2 minutes after
reconnecting the hob to the power
supply, the following steps.
Ÿ
Make sure all cooking zones are switched
off.
EN 45