Hilti TE 700-AVR Manual Original página 26

6. Before use
6.1 Fitting and adjusting the side grip 2
en
1. Disconnect the mains plug from the power outlet.
2. Release the side grip clamping band by turning
the knob.
3. Relax the tension on the side grip (clamping
band) and slide it over the chuck and onto the
shank.
7. Operation
DANGER
Always hold the power tool securely with both hands
on the grips provided. Keep the grips dry, clean and
free from oil and grease.
7.1 Preparing for use
CAUTION
Wear protective gloves when changing insert tools
as the insert tools get hot through use and they may
have sharp edges.
7.1.1 Fitting the insert tool 3
NOTE
The chisel can be adjusted to 24 different positions
(in 15° increments). This ensures that flat chisels and
shaped chisels can always be set to the optimum
working position.
1. Disconnect the mains plug from the power outlet.
2. Check that the connection end of the chisel is
clean and lightly greased. Clean it and grease it
if necessary.
26
4. Pivot the side grip into the desired position.
5. Secure the side grip by tightening the knob.
6.2 Unlocking the power tool (theft protection
system)
See section "Operation / TPS Theft Protection System
(optional)".
6.3 Use of extension cords and generators or
transformers
See section "Description / use of extension cords".
3. Check that the sealing lip of the dust shield
is clean and in good condition. Clean the dust
shield if necessary or replace it if the sealing lip
is found to be damaged (please refer to the "Care
and maintenance" section).
4. Push the chisel into the chuck and rotate it while
applying slight pressure until it engages in the
guide grooves.
5. Push the chisel further into the chuck until it is
heard to engage.
6. Check that the chisel has engaged correctly by
pulling it.
7. In order to position the tool, turn the function
selector switch to the 'Turn chisel' position.
8. Rotate the chisel to the desired position.
9. In order to position the tool, turn the function
selector switch to the 'Lock chisel' position.
10. Turn the chisel until it locks in place (24 catch
positions per revolution).
7.1.2 Removing the chisel 4
DANGER
Do not lay a hot insert tool down on flammable
materials. This could cause the material to ignite,
resulting in a fire.
1. Disconnect the mains plug from the power outlet.
2. Open the chuck by pulling back the locking
sleeve.
3. Pull the chisel out of the chuck.